Studi Efek Gangguan EMP (Elektromagnetic Pulse) pada Perangkat Elektronik

  • Jhav Sund Oktoricoento Universitas Muhammadiyah Prof. Dr. Hamka, Jakarta
  • Muhammad Ramdani Universitas Muhammadiyah Prof. Dr. Hamka, Jakarta
  • Sahrudin Sahrudin Universitas Muhammadiyah Prof. Dr. Hamka, Jakarta
  • Kun Fayakun Universitas Muhammadiyah Prof. Dr. Hamka, Jakarta
  • Harry Ramza Universitas Muhammadiyah Prof. Dr. Hamka, Jakarta
  • Akhiruddin Maddu Institut Pertanian Bogor

Abstract

The existence of electronic devices in human life is very close today. Various areas of human life is always supported by electronic devices, ranging from the field of telecommunications to the security field, one of which is the surveillance system. Utilization of electronics in the military field is now known as Electronic Warfare (EW). One type of electronic attack is electromagnetic jamming. This study aims to examine the effect of EMP and determine the value of interference from the electromagnetic field to the surveillance system in the form of mini cameras. Variables in making measurements consist of source voltage, interference distance, and coil that each value is varied. Formulation of measurement data using Design Expert 11 with D-Optimal Response Surface method. The results showed that the maximum magnetic flux value generated by the signal jammer was 0,479 Wb / m2, the maximum interference value at the mini camera spectrum level was 2 dB, and the maximum interference value most often occurred at 4,9 MHz. The correlation coefficient value of the influence of the electromagnetic field on surveillance system between the predicted value of the simulation and the direct measurement value is -0,55093384.

Author Biographies

Jhav Sund Oktoricoento, Universitas Muhammadiyah Prof. Dr. Hamka, Jakarta
Program Studi Teknik Elektro Fakultas Teknik
Muhammad Ramdani, Universitas Muhammadiyah Prof. Dr. Hamka, Jakarta
Program Studi Teknik Elektro Fakultas Teknik
Sahrudin Sahrudin, Universitas Muhammadiyah Prof. Dr. Hamka, Jakarta
Program Studi Teknik Elektro Fakultas Teknik
Kun Fayakun, Universitas Muhammadiyah Prof. Dr. Hamka, Jakarta
Program Studi Teknik Elektro Fakultas Teknik
Harry Ramza, Universitas Muhammadiyah Prof. Dr. Hamka, Jakarta
Program Studi Teknik Elektro Fakultas Teknik
Akhiruddin Maddu, Institut Pertanian Bogor
Departemen Fisika Fakultas Matematika dan Ilmu Pengetahuan Alam

References

US Army. FM3-12 Cyberspace and Electronic Warfare Operations. vol. 5. no. 17-2. April 2017. Washington DC : Army Publishing Directorate.

Suhendro, Budi, Djiwo Harsono, dkk. Modifikasi dan Otomasi ‘Handheld’ Jammer Berbasis Mikrokontroler ATMEGA 8535. pp. 388–394. 2012. Yogyakarta. Seminar Nasional VIII SDM Teknologi Nuklir. ISSN 1978-0176.

Rustamaji, E. Djaelani. Radar Jamming Suatu Konsep Rancang Bangun. vol. 11. no. 2. pp. 71–80. September 2012. Bandung : J. Electrans. ISSN 1412 – 3762.

Sarkar, Partha. A Compact And Portable EMP Generator Based on Tesla Transformer Technology (Thesis). UK: Loughborough University, 2008. hal 23-24.

Eckl, Bence dan Szabo Norbert. Design And Simulation Of Electric Arc Generator Device. April 2016. Hungaria : University of Miskolo. ISBN 978-963-358-113-1.

Anggoro, C. J. dan I. E. Santosa. Distribusi Medan Magnet di Sekitar Kumparan Berarus Listrik.vol. 2. pp. 6–9. ISSN : 0853-0823. Yogyakarta : Prosiding Pertemuan Ilmiah XXIX HFI Jateng & DIY, 25 April 2015.

Djamal, Hidajanto, Iwan Krisnadi. 2013. Gangguan Telepon Seluler Pada Transportasi Udara Komersial. pp. 119–144. Vol. 4.no.2. Incom Tech, Jurnal Telekomunikasi dan Komputer.

Gambar modul XL4015. (https://www.google.com/search?q=modul+xl4015, diakses 02 Juli 2018)

XLSEMI Datasheet. Datasheet 180KHz 36V Buck DC to DC Converter Features XL4013 General Description Datasheet 4A 180KHz 36V Buck DC to DC Converter Pin Configurations. pp. 1–10. (https://datasheetspdf.com/pdf/786208/Xlsemi/XL4015/1, diakses 02 Juli 2018)

H. Ramza et al. 2018. Pemodelan Medan Magnetik Dua Kawat Gulungan Helmholtz Modelling of Two Helmholtz Coils Magnetic. pp. 259–276. No. 27.Vol. 07.Ukrida : Jakarta.

J. Antony, S. Coleman, D. C. Montgomery, M. J. Anderson, and R. T. Silvestrini. 2011. Design of Experiments For Non-Manufacturing Processes: Benefits, Challenges and Some Examples. Proc. Inst. Mech. Eng. Part B J. Eng. Manuf. vol. 225.no. 11. pp. 2078–2087.
Published
2018-12-18
How to Cite
OKTORICOENTO, Jhav Sund et al. Studi Efek Gangguan EMP (Elektromagnetic Pulse) pada Perangkat Elektronik. Prosiding Seminar Nasional Teknoka, [S.l.], v. 3, p. E1-E7, dec. 2018. ISSN 2580-6408. Available at: <https://journal.uhamka.ac.id/index.php/teknoka/article/view/1237>. Date accessed: 24 jan. 2019. doi: https://doi.org/10.22236/teknoka.v3i0.1237.

Most read articles by the same author(s)

Obs.: This plugin requires at least one statistics/report plugin to be enabled. If your statistics plugins provide more than one metric then please also select a main metric on the admin's site settings page and/or on the journal manager's settings pages.